Ansys designpoints not updating

Topics relate to Fluent, CFX, Turbogrid and more

  1. All Channels
  2. Fluids
  3. DOE analysis: Some Design Points update fail and need user input before update

DOE analysis: Some Design Points update fail and need user input before update

January 30, 2020 at 2:59 am Subscriber

Hi, I'm doing some DOE analysis via ANSYS 17.2.
100 design points were importe in DOE table. Half of them updated successfully but there are 47 DPs updated fail.
The fail message shows "(DP 2) The Setup component in Static Structural for Design Point 2 requires user input before it can be updated. For instructions on how to address the cell in its current state, click the blue triangle in the lower right corner of the cell."

I'm pretty sure my BCs, mesh, etc are correct because I use same one finished thousands times.

This problem only happened in two specific models.

January 30, 2020 at 10:49 am Forum Moderator

Open them up and have a look: depending on what you've got set the model may not be viable or something else is "odd".